Low Maintenance Finish

• Extremely durable and mark-resistant finish for low maintenance applications.
• High gloss acrylic polymers stay clean, clear, and shiny to reduce maintenance.
• Non-yellowing, low maintenance formula offers superb black mark and scuff resistance.
• Ideal for reduced burnishing programs (once per week).
• Use on vinyl tile, rubber, linoleum, terrazzo and quarry tile floors.
• Excellent seal properties.

Properties

• Type – Metal Interlock Acrylic
• Form – Opaque Liquid
• Odor – Bland
• Color – Milky White
• Weight per Gallon – 8.60 Lbs.
• pH – 8.1-8.3
• Floor Solids – 18%
• Coverage – Up to 3,000 Sq. Ft. Per Gallon (75 m² per liter)
• Dry Time – 30 Minutes
• Slip-Resistance – UL Classified
• V.O.C. Content – < 260 gm/l

* Properties are typical and subject to usual manufacturing tolerances.

Directions

Application:

1. Strip floors to remove old waxes, sealers and finishes.
2. Rinse thoroughly and let dry.
3. With clean rayon mop apply thin, even coats of Durabrite.
4. Under normal conditions, allow to dry for 30 minutes between coats.
5. For best results, apply a maximum of 4 coats in 24 hours.

Maintenance:

1. Daily: Sweep or dust mop as necessary to remove gritty soil.
2. Dirty Floors: Clean with 2-4 oz. of Blue Concentrate SC per gallon of water. Rinse and let dry.
3. Traffic Area: Clean with 2-4 oz. of Blue Concentrate SC per gallon of water. Rinse and let dry. Apply additional thin coats of floor finish to traffic lanes as needed.
4. Buffing: If desired, periodic burnishing with blended hair pads will enhance appearance.
5. Periodic Complete Maintenance: Ordinarily, stripping is not required more than (1) or (2) times per year. Use up to 32 ozs. of our stripper per gallon of water.

See label directions and SDS for complete usage and safety instructions.

Application

• Durabrite is very easy to apply with a standard finish mop and dries perfectly clear.
• For best results in high traffic locations (such as supermarkets) and entranceways, apply four coats the first night, then follow-up a few days later with four more coats. This gives you the desired film thickness from which to properly maintain your floor.
• Durabrite is a fast curing (~2 hours) finish and therefore is ideal for areas where traffic is heavy just after application. It is also ideal for application to newly installed VCT floors.

Pads

.	Propane	Battery	Electric (1000+ rpm)
3M	Tan Burnish	Tan Burnish	Tan Burnish
Americo	Combo	Combo	Porko Elite
ETC	Gorilla	Gorilla	Gorilla
Glit	Jackeroo	Jackeroo	Jackeroo
Microtron	PL Natural Poly	PL Natural Poly	PL Natural Poly
Norton	Grizzly Bear “Lite”	Grizzly Bear	Grizzly Bear

* These are generalized classifications based on market research. Terms and definitions may be different from manufacturer to manufacturer; however, the above information will help to determine pad compatibility with various floor machines and Essential finishes on the market.